Which cisco ios switch command is used to configure the use of lacp on an interface?

#Which cisco ios switch command is used to configure the use of lacp on an interface? how to
#Which cisco ios switch command is used to configure the use of lacp on an interface? full
#Which cisco ios switch command is used to configure the use of lacp on an interface? series

All fixed ports can be configured for either full or half duplex. Applicability of this command depends on the device to which the switch is attached. Specifies that the interface should automatically detect whether it should run in full- or half-duplex mode.Д¬ertain interfaces can be configured to be either full duplex or half duplex. Specifies that the interface is in half-duplex mode. Specifies that the interface is in full-duplex mode. Use the no form of this command to return the interface to its default value. Use the duplex interface configuration command to specify the duplex mode of operation for an interface.

#Which cisco ios switch command is used to configure the use of lacp on an interface? how to

The following example shows how to clear the switch MAC address table: If more than one optional keyword is used, then all of the conditions in the argument must be true for that entry to be deleted. Specific subsets can be deleted by using the optional keywords and values. This command deletes entries from the global MAC address table.

Д¬lear all the addresses for an interface. Use the clear mac-address-table EXEC command to delete entries from the MAC address table. Specify the interval between Hello Bridge Protocol Data Units (BPDUs).Д¬hange the interval the switch waits to hear BPDUs from the root bridge.Д¬onfigure the priority of an individual bridge or the likelihood that it will be selected as the root bridge.Д¬onfigure the Spanning-Tree Protocol priority of a port.Дefine the type of Spanning-Tree Protocol. Specify the forward delay interval for the switch. Place this interface into a port aggregation groupД«roadcast traffic is disabled if too many broadcast packets are seen on this port.Дisable Spanning-Tree Protocol for the switch. Prevent the flooding of unknown destination MAC addresses and multicast address on this interface.

Specify the duplex mode of operation for an interface. Set a primary or secondary IP address of an interface. Set the length of time that a dynamic entry can remain in the address table.Д®nable address learning on the current interface.ДЄdd entries to the address table that are known to be secure addresses.

#Which cisco ios switch command is used to configure the use of lacp on an interface? series

Table 2-1 Commands Created or Changed for the Catalyst 2900 Series XL CommandsДelete all addresses currently in the MAC address table.Дisplay the blocking of unicast and multicast filtering for the port.Дisplay the ports that have been assigned to groups.Дisplay the ports that have had port monitoring enabled for them.Дisplay the ports that have had port security enabled.Дisplay the disposition of broadcast-storm control. So even though it may seem overwhelming at first, keep at it as no one said getting your Cisco certification would be easy! As you progress through your CCNA exam studies, I am sure with repetition you will find these commands becoem second nature. So to assist you, below we provided you a list of Cisco Switch Commands you may see on your CCNA exam. In preparation of your CCNA exam, we want to make sure we cover the various concepts that we could see on your Cisco CCNA exam.